All ideas

Display exception reason detail on iPad at dropoff. Typical workflow for RF picking is to give reason for exception.

Support alternate pick locations, supplied by the WMS, as backup pick locations for short or skip exceptions.

Get a report in the Portal that shows the bot behavior in the past

Ability to create areas within a map where robots can be bounded for work, but allowed to leave for charging. VF Prague wants to use pick and pass between the north and south sides of floor (via 2 separate maps, N&S), but allow any robot to go...

Decrease the width of the top shelf / ceiling shelf of the Vector bot to increase the window fit space on the top shelf. This would resemble just an attaching bar that met the requirements of keeping the configuration stable, while providing more ...

Problem Since the FM map does does not display zone & aisle attributes, the LP# is the primary method to identify a specific location on the Locus floor. However, the only way to locate a specific LP# is to visually scan the LP#s displayed on ...

Ability to adjust the display of ToteID on the Tote Positions Portion of the Pick UI.

The robots could use the iPad's speaker or some alternative device to emit some type of beep sound (see sample sound below), similar to that used in MHEs, when they are in motion. https://www.youtube.com/watch?v=diqmMaJOBwg

All totes should be allowed to be inducted. Once Go is selected then the bot should identify any dupe totes. or it should commence its journey, complete the correct totes and return with any duplicates

Have a mounted light fixture above the bot that can radiate light in all directions increasing the likely hood that a light ray might become visible to a working associate.